alignment

I need to attach to existing pipe in the floor and then come up behind bathroom units, which only afford 50mm of clearance. The attached picture is my first attempt, which is not permanent as the connection in the floor has been done using compression. I spent ages lining everything up and...

I have a misaligned uPCV external door with butt hinges (not sure which manufacturer, but is 3D adjustment type). The bottom hinge is clearly out of alignment and recently a small screw fell out the bottom - my guess is that it has just worked loose over time. I have tried to push and screw...

I’ve used a couple of 90 degree wall plate elbows to fit a shower arm and hand shower into. My question is the shower arm needs backing off about 1/4 turn and the hand shower needs backing off 3/4 of a turn. Now I’m going to use loctite 55 but also wondered if it’s worth using some kind of fibre...

Hi, I've fitted a metal Kaldewei bath with a Bristan Quest mixer tap. The tap holes were pre-drilled and the centres are fine. I tested the electric shower above and water leaked through the base of the tap and through the holes, onto the floor. The issue is that the holes in the bath are 35mm...

I have just installed new UPVC and having a few troubles getting the alignment setup right. The flag hinges on the door looks as below. From the brief instruction sheet I have it seems the bottom adjuster moves the door up / down. The right adjuster moves the door right / left and the top...