Hey everyone.
Long time lurker here but I've only just signed up.
****
tldr;
I want to lower my ceiling using steel beams on party walls to increase attic headroom. The house is stripped out right now, so I have a lot of freedom. Can anyone advise on beam sizes, bearing depths etc?
****
I'm...
Hi, so I am assessing if my exterior garage/outbuilding can support the weight of a wall mounted weight plate storage rack (See picture two for the rack), there would be two racks both weighing at 80KG~ when plates are fully loaded at two spread-out locations as marked in red, photo 1.
The wall...
Our chippy has chocked up the ends of the double beams (2 of c24; 170x47mm, bolted together) around our new stairwell with a short small softwood wedge (about 30mm wide) banged in between the middle of the beam pair and the next brick below in the supporting internal brick walk. He has now gone...
Our chippy has chocked up the ends of the double beams (2 of c24; 170x47mm, bolted together) around our new stairwell with a short small softwood wedge (about 30mm wide) banged in between the middle of the beam pair and the next brick below in the supporting internal brick walk. He has now gone...
Looking to get an internal wall removed in my kitchen. This wall runs parallel to my joists. When i took off the frame I noticed that there is OSB under the plasterboard. Why is this? Kitchen cabinets on the other side of the wall so is this likely why?
wall is definitely parallel to the...