digistat

I have a Worcester 28CDi combi-boiler witted with a wireless thermostat which has stopped working. The model numbers are: Receiver 7716 192 005, Transmitter 7716 192 004, Complete system 7716 192 006. The transmitter and the receiver have stopped communicating with each other, so I have...

HI all. I have got a Worcester greenstar 28i junior combo boiler. The thermostat currently on there is a worcester digistat. This digistat talks to the boiler via RF. I am looking to get the Drayton Wiser thermostat system but want to check it will be compatible with the boiler. To add...

The system is 10 years old. I have changed the Digistat battery after the icon started flashing but it still flashes. It's a new battery from a recently bought pack. I have already changed it twice but it is still flashing. Any advice please? Thanks

Hi. I need to replace a 3 wire room stat with the above but am having no joy. Due to the construction/layout of the house I have to site the base unit where the stat was. I’ve wired as per the diagram (I think) All appears to be working/paired but although it shows that it is calling for heat...

Hi, I have a Drayton Digistat 1 Room Thermostat which ran out of Battery. I replaced with a new set and it ran out within a month. I've now replaced with another new set of Alkaline Batteries (GP Ultra) and it again ran out within minutes. Is there a short somewhere which is draining the...

Hi! Hope you can help. Typically days before Christmas the wireless system on the boiler decides to pack in. I can see the issue with the transmitter, the battery terminals inside the Drayton Digistat RF2 unit are broken, eroded completely. My question is - the receiver is the Drayton...

Good evening, I am in the process of installing the Hive Receiver and just need to replace the Drayton Digistat 2. Can anyone advise, having looked at the pictures attached, what wires should go where? I have a Baxi combi boiler. The wires going into Digistat, are only common and on. The hive...

Hi my Drayton Digistat is not firing my boiler up. I have changed the batteries in the controller, replaced the capacitor in the receiver and reset it numerous times. The boiler is working for hot water. When the controller sends the signal to switch the heating on the receiver alarm light...

Hi, I have a Drayton Digitstat+RF thermostat synced with an SCR unit connected to a Worcester combi-boiler. This has worked fine for several years, but for the past few weeks the boiler goes on and off independently of our thermostat. When the boiler is off, raising our thermostat above room...

Hi guys, I've got a Drayton Digistat SCR that's stopped working, meaning I can't turn my heating on. The transmitter (a 2RF) is fine and it has new batteries. The fault seems to lie with the receiver, which has no lights coming on at all. After a bit of searching online, I've tried turning the...

Happy new year everyone. - I have one of these old Drayton wireless Digistat RF1 is there any way to make the transmitter go all the way down to 5 degrees centigrade at all (documented or not documented, or taken apart and 'hacked' with shorting out something inside) the lowest I can get it to...

Hi folks, Would truly appreciate any help. Have a Worcester Greenstar 30SI combo boiler and the digistat will not turn the heating on. It seems that the tenperature can't be raised, so the + button isn't working. Have tried everything but can't solve it. Boiler isn't old so hoping it is...