dryer

My Hotpoint SUTCDGREEN9A1 dryer isn’t reversing. The dryer turns clockwise just fine, but when it stops periodically to turn anticlockwise, it doesn’t turn, but I can hear the heater/pump, etc still working without the drum spinning. Can anybody please point me in the right direction? Have...

I have an Electrolux gas dryer model EIGD5OLINO (2013) that won’t turn on. The display blinks once or twice but then nothing. When I open the dryer door, the interior light will go on and then go off when the door is closed so that makes me think it is not the door contact switch. The issue...

Hi, looking for some help, I have a Bosch Classix 7 tumble dryer model WTE84106GB/48 and recently I noticed that no condensate is being collected in the drawer. Otherwise it appears to work but presumably isn’t drying as quickly or as efficiently as before. The dryer is almost 5 years old now...

Hello - using a Bosch series 8 heat pump condensation dryer with AutoClean function (Bosch WTX87M09FF). Machine is 1 month old, brand new and works fine. I have followed the directions in extreme detail to install the evacuation hose on the dryer so as not to have to empty the condensation...

Hi. If anyone can help... My indicit tumble dryer wont dry the clothes as efficiently. It was a sudden change. I've tried getting rid of lint in the bit that catches it. Ives washed to filter at the bottom of tha machine that had a but of lint build up. The condenser is empty of water. The...

My Siemens dryer E750 has developed a fault where it cuts out. Engineer reports it's due to a circuit board dry joint; suggested replacement. The machine will turn on and work fine for a while. Then it stops. No power reaches the control panel which looks like the machine is off. But there is...

I had the common Miele Dryer issue of starting a cycle then switching off after 30 seconds or so. And also the issue a cycle running but no heat. I tired the NTC switch etc and none of that worked. Finally I got a Miele engineer round and he said it was simply that the mesh vent strips that...

Hi all. Trying to find what this fault code on my T294C Dryer means: It starts up but does not heat up. Have had previous faults of starting up with heat but then shutting down after a few minutes with beeps. I have trued a new Miele NCT (temp sensor) which made no difference. Wiping the...

Hi all. I have the seemingly common fault of my Miele T294C dryer shutting down after 5 mins of blowing cold air and beeping on all settings. BUT! If I wipe / clean the door interior seal down (on the machine body side not the actual door) it will work??? Would appreciate any pointers as to...

Hi there, Needing some help here with my HotPoint washer/dryer WDL520: It goes through the wash cycle till it reaches the drain/spin cycles, when it starts to flash all the lower buttons and the start/stop button. I have gone onto check the pcb see if any capacitor is not working but they all...

Hi All We`d like to get a tumble dryer for our garage and am looking at vented ones. The issue I have is that there is only one wall that I can put a vent on and that is about 6cm away from our neighbours garage wall so its impossible to get to from the exterior to fix a cover/flap, is that...