elbow

I’ve used a couple of 90 degree wall plate elbows to fit a shower arm and hand shower into. My question is the shower arm needs backing off about 1/4 turn and the hand shower needs backing off 3/4 of a turn. Now I’m going to use loctite 55 but also wondered if it’s worth using some kind of fibre...

I'm installing a shower head elbow wall plate (for the first time). The depth of the 1/2 inch threaded socket isn't enough to clear the depth of the backer board (see attached picture) plus a further 12mm of tile and adhesive. The joint between the shower arm and the elbow would be right in the...

Hi I’ve got an outside tap with blue mdpe pipe. 2 questions 1)I’d like to insulate it - guessing with the standard grey foam tubes. do I insulate the wider elbow connections and how/what with? 2) What’s the best way to paint the insulation so it blends in on the render wall. Thanks in advance.

Hi, Is it possible (and how?) to dismantle the push fit connection on this elbow? Or is it easier to just cut the pipe?))) Kind regards,

Hi, I have installed a wall plate elbow (see attached the only photo I have of this) for shower hose elbow outlet, but the problem I have is that after 10mm WP board+grout and tile (assume 15mm WCS), the elbow will be short of the tile outer edge by 10-15mm. This will be an issue as how would I...

Hiya, I need to put a stop cap/end on one of this old elbows. What I would like to know is by looking at the picture, does anyone one knows if I could get a stop cap with this kind of old elbow? Btw the pipe size is 15mm. Cheers!