extractor hood

Have removed old cooker hood & chimney, leaving me with what’s shown in the photo. Presuming my next step is to remove the hardwiring that goes into the socket from the existing motor so I can then remove what’s left of the old appliance, leaving just the socket & then hardwire new appliance...

Recently took the extractor hood and splashback down to replaced and noticed especially over the last few days thanks to storm eunice. You can see straight outside (n) no wonder the kitchens always felt cold,and never seems to hold the heat. Any advice on what vent I should get for the...

I have a simple question, to which I have been getting conflicting answers: Can I cut a section out of a flat roof joist to run through some ducting? Happy for it to be flat channel. The rafters are 170mm. I've seen some info but think it's about floor boards: I have seen enforcement...

I have just installed a new kitchen and have a new extractor hood to put up. We are thinking of tiling either 3/4 of the wall, or right to the ceiling with a small white brick tile. What I was wondering was; do I fir the extractor to the wall first, and tile around it (it's a square hood so...