flame loss

Hello Oil Boiler Trianco Eurostar Premier 100/125 Condensing boiler. Runs fine for about a minute then flame dies (sounds like the solenoid is closing oil supply) after 7 seconds it fires again and continues running. Fan is running all the while. Cycle repeats until the boiler gets up to...

Hi! My boiler Ideal Logic 30 Combi shows flame loss error (F2 fault). Boiler is in the newly property and so far has been used just for hot water, which worked fine. The problem appeared when I tried to switch on central heating (The CH system has been drained, flashed and refilled).With "C" on...

Hi all. So I have had my RGI have a look at the boiler and we have run out of ideas. Boiler is a Biasi M296.24SM/C The air pressure sensor has been swapped as that was the original fault indicated by the panel lights. Now the error message showing on the lights is “problem with ignition...

Hello All, I am in need of some help. I very recently had a combi boiler fitted, few weeks ago. The problem is it only works without a facia plate on, I am reffering to the big white plate that has the dial names and legend etc. As soon as I put the facia plate back on again it makes a loud...