lightwave

Good evening I have recently moved house and began to upgrade light switches and mains sockets to the light wave smart socket/switches Wanted some advice to upgrade my 2 gang light switch It is located in the living room and controls the living room and landing lights The landing light can...

Installed a Lightwave 1 gang switch and now the LED light is flickering when off. It is like the switch is not turning off the light correctly, and that the light is running in a dimmed state. Then light is dimmable! I have checked the wiring on the switch and this is correct (I believe). Any...

Hello, I have Lightwave connected in all rooms in my house. In one of the rooms the dimmer switch does not turn on yet there is power to the switch. Any ideas why it does not switch to on?

Decided to replace my Lightwave connect series switches with the Lightwave smart series switches, to get greater LED compatibility and native homekit support. I thought the new Lightwave switches would have the same connections as the old switches, alas they do not. The 2-gang connect switches...

I have a set of lights upstairs and a set of lights downstairs. There is a 2-gang switch at the bottom and a 2-gang switch upstairs. So both switch locations allow me to control both upstairs and downstairs with the 2-way 2-gang setup. Both upstairs and downstairs are on different circuits...

I have just purchased 1-gang and 3-gang lightwave light switches. I have installed the 1-gang in the passage and apparently it's the slave in a 2-way circuit. The 3-gang switch in my living room has 2 normal switches and one which connects to the passage in the same 2-way system. Have a look...

Hi, Need help to change and old lightwave dimmer to a new model. The old model had the following set-up: But the new model has just the following set-up and instructions: What should I do with the second L wire, since there's only 1 L entrance in the new 2 Gang model. Thank you

Hi, I currently have two light switches in my lounge. These switches control 2 lights. Either switch can be used to turn both lights on/off at the same time. I have attached images of the wiring within each box. I'm trying to replace these switches with a Lightwave master/slave combo. These...

Hi, Looking for guidance on replacing existing switches in our kitchen with some LightwaveRF ones I've bought. (LW420 Dimmer (2 gang) & a LW450 2-Way Dimmer (1 Gang)) It's a bit confusing as it uses a signal wire and if wired up incorrectly could kill the switches. Would it be a problem using...