lightwaverf

Installed a Lightwave 1 gang switch and now the LED light is flickering when off. It is like the switch is not turning off the light correctly, and that the light is running in a dimmed state. Then light is dimmable! I have checked the wiring on the switch and this is correct (I believe). Any...

Hello, I have Lightwave connected in all rooms in my house. In one of the rooms the dimmer switch does not turn on yet there is power to the switch. Any ideas why it does not switch to on?

Decided to replace my Lightwave connect series switches with the Lightwave smart series switches, to get greater LED compatibility and native homekit support. I thought the new Lightwave switches would have the same connections as the old switches, alas they do not. The 2-gang connect switches...

I have a set of lights upstairs and a set of lights downstairs. There is a 2-gang switch at the bottom and a 2-gang switch upstairs. So both switch locations allow me to control both upstairs and downstairs with the 2-way 2-gang setup. Both upstairs and downstairs are on different circuits...

I have just purchased 1-gang and 3-gang lightwave light switches. I have installed the 1-gang in the passage and apparently it's the slave in a 2-way circuit. The 3-gang switch in my living room has 2 normal switches and one which connects to the passage in the same 2-way system. Have a look...

Hi, I'd like to use a LightwaveRF in-line dimmer on a light fitting that has a transformer and low voltage bulbs. The dimmer can be set to disable the dimmer function, so provides full 240V when on, but like most LightwaveRF lighting switches, it leaks voltage when off. I'm trying to find out...

Hi, I currently have two light switches in my lounge. These switches control 2 lights. Either switch can be used to turn both lights on/off at the same time. I have attached images of the wiring within each box. I'm trying to replace these switches with a Lightwave master/slave combo. These...

Hi, Looking for guidance on replacing existing switches in our kitchen with some LightwaveRF ones I've bought. (LW420 Dimmer (2 gang) & a LW450 2-Way Dimmer (1 Gang)) It's a bit confusing as it uses a signal wire and if wired up incorrectly could kill the switches. Would it be a problem using...