pump issue

We had our kitchen renovated and our 2 year old Worcester boiler was moved to the loft and the HIVE receiver was moved from the kitchen to the airing cupboard. We started to notice that after the hot water had been on the boiler bump would continue to run when it should go off after 10/15mins...

Hi all, just wanted to get some peoples opinions. A new customer of mine has asked me to look into what he can do about his heating system not heating up downstairs radiators sufficiently. He has recently had a extension and a new 32kw oil system boiler with 15-60 130 pump fitted outside. The...

Hi I have a Beko Dishwasher. It’s about three years ago and it really hasn’t worked since I got it. Every time it powers in, does the wash cycle and when it gets to the drain cycle it blows the fuse in the box. Today I’ve laid it on its side and got the bottom panel off and the insulation...

Hello Folks and Especially those that are averse to Vaillant prooblems I have an Ecotec plus 637 systems boiler not sure if its S or Y plan but will poost pictures. Theres a wireless room stat in same room and a Valliant control center too. All has been running fine for absolutely ages until...

Hi my really old large house used to be a real mess in terms of several old heating systems that were cobbled together and extensions to it. Not to mentions redundant pipework from Back boilers and a Rayburn/Aga style device in the kitchen. Now - I have the original gravity fed Potterton...

Hi All, I have a strange issue with my shower pump as in its suddenly stopped working :) So I have 2 showers and starting either shower the pump fails to start. However if I cycle the power to the pump it will run for a few seconds and then if the shower is started in runs for the duration of...

I have a unvented CH & HW system Boiler is Ideal Classic FF260. The whole CH and HW system has been working fine, both activating and deactivating on timed control and through room thermostat. I now have an intermittent issue where both HW and CH can be off on the timing programmer and yet the...

Hello all, I'm at my wits end... I have fairly recently taken the plunge and re fitted my entire bathroom. I should probably add at this point that I am not a plumber and before I undertook this mammoth task I had no plumbing experience whatsoever. I hope that this has not now let me down at...

Hope someone can help - this is my first post. We haven't serviced our warmflow oil system for quite a while. It's worked no problems for years. Yesterday it locked out. Pressed the the reset and on the second go it lit and stayed going for a couple of hours. Then tried to light again in...

Over the last few days we are having problems with the boiler cutting out after a few minutes. Hot water seems to be fine (although it may be taking a bit longer than normal to heat up), and the flames are all lit. They remain lit whilst the hot water is running (which is correct). The...