pyonix enforcer

Hi Folks, Hoping you can help me, I had the ProControl+ app on two devices (android + apple) for the past 14 months or so and had no issues up until a few months ago. In August 2021 My alarm engineer came out to perform annual maintenance, he did a full system check / test and added two more...

We had a problem with the Alarm going off reporting input 3 tamper on input. If we reset the alarm kept going we had to call an emergency alarm specialist out. He said the fault was the batteries in the siren when they became flat. He and disconnected the battery in the siren and the battery in...

I have a warning (amber yellow triangle) with the message “Active Faults Service Required”. This appeared at midnight exactly and the panel log has “00:00:00 Service Required” There have been a couple of log entries in the three days since the warning showed. They are both: “Wireless Ch To”...

Hi l have a Pyronix enforcer and have 2 wired zones available and would like to put 2 pirs on the one zone .The manual only shows 1 per zone using resistors and 3 wires + 12v -12v and 1 wire for tamper/ alarm anyone help as how to have an extra pir thanks Steve

Hello everyone. . i have PCX 46L Control panel and accessories PCX-LCD keypad, KX15DD Wired detector And wireless devices PIR kx12dq & Delta bell but when I do learn devices I can't find wired devices (Detector ) any one can give idea how to fix this issues ? where to connect panic button on...

Hi, New on here having issues with my Pyronix and attaching smoke-we sensors ...go in add wireless device it all syncs up ok but then when I exit the engineers menu I get a wireless mismatch error ?? (see photos) any help would be appreciated as currently have no smoke alarms (I'm Guessing that...

HI I know the Enforcer V10 has Digi Wifi but can this board be programmed into the V9. Or does the V9 need updating to V10? how is this done?

Hi It was all going so well....I have mostly set up the system (there have been a a few useful threads on here to keep me on track so thanks for those also) and it mostly seems to be working as I wanted, although I still have to check a couple of things. My issue is now that I am trying to set...

Hello all, I'm looking at installing a new wireless home alarm with 6 zones (4 PIRS, 2 door contacts). The two I have read most about are 'Pyronix Enforcer' and 'Visonic PowerMax'. I have also asked local installer and most local installers would prefer Visonic. I know on spec Pyronix is two...

I need a DIY wireless alarm system because i move regularily and want to take it with me, but don't really want to have to compromise on capability, despite having to choose a DIY option. From reading in this forum I have shortlisted the 3 below, but its not based on any real understanding of...