saw

Hi Im after a couple of mitre boxes 100mm high which i can screw down to a board (makeshirt workbench) so that I can do some accurate timber cuts for garden. The 2 mitre boxes i would position apart to suit the desired wood width (then screw them to the board) I could move them closer or...

I wasn't sure which forum to post this under, but my problem is to do with installing underground soil pipes which I guess is a builder's job. I am installing a new ground floor toilet that is located several metres from the existing foul water drain, and the new toilet will also be in the...

I have a table saw which has stopped working.smoked once from the relay. Now if I try to restart it. Motor goes very slow if switched kept pressed in otherwise if just pushed motor goes for a second and stops. Can the relay be repaired or need to be replaced? I have attached photos of the...

Would a £70 Erbauer reciprocating saw be ok for cutting out a doorway in a single leaf internal breeze wall, using masonry blades? The masonry blades aren't free but I won't have cutting discs in the house, they're banned. Not a supporting wall. Thanks Dain

Hi, I've never used a multi-tool, and I'm thinking of buying this one: https://www.ebay.co.uk/itm/332945384811 However, I have a question: will I be able to mount on it the blades from other brands (e.g., Fein, Makita, Bosch). Do they all use a standardised mounting mechanism? TIA