t&g

  1. S

    T&G cladding a room what order of install?

    Hi all I am finally finishing off the summerhouse and the last bit to do is the internal walls. These are being clad with horizontal T&G. The room is 2.8m x 2.5m with the longest walls being the back wall and front (75% windows and doors) I was intending to start with the back wall but wondered...
  2. S

    T&G Shed door

    Hi all, I am just about to fit a shed door to my shed/summerhouse. The shed is made from T&G shiplap timber and I was going to use the same wood for the door. Every photo/design always shows the door with the T&G vertical as opposed to horizontal ( which is the format of the shed cladding) Is...
  3. Sunjat

    How to fit T&G floorboards which meet in the middle of the joist notching

    Hello fellow forum users, Quick question for experienced carpenters/builders out there. My floor boards currently meet right in the middle of where joist notching is. What's the best way of fitting the t&g floorboards in my case, so these don't sag and bend the copper pipes then walked on...
  4. B

    T&G Shiplap Vertical

    I've bought some T&G Shiplap cladding for my garden room. The intention was to mount it horizontaly but I think it would look way better vertical. Can anyone see any issues with that? I will counter batten to create an air gap, and I have installed a breathable membrane over the OSB sheathing...
  5. T

    engineered T+G floor: seamless plywood vs many separate strips? + underlay

    Hi all, we ordered some numbers of samples from different shops of engineered t+G oak floor. All of the samples we received (bar one) have the ply substrate made out of thinner strips laid next to each other, as opposed to one unique piece of plywood. On the other hand, when I look online at...
  6. acurachris

    Access after installing first floor joists and boards

    Hi I am going to be installing the first floor joists and boards on my house extension and have a question about access! :unsure: After the joists are installed I intended to install the floor t&g boards on top which is all great, although how would I gain access to my new floor when it's...
  7. O

    Old suspended Fl; insulation, breather membrane, plywood between joists

    Sorry, this is a nested question.. Old suspended 1960s floor comprises: 3" void, 3" timber heights (sat on engineering bricks, levelled with cement), floorboards. Joist spacing sees 440mm approx inbetween joists. Joists are 2.5" wide. Goals: - insulate between timbers - UFH: install over tray...
  8. A

    How to measure tongue and groove width?

    How do i measure tongue and groove width? Is it measured from end to end including the tongue or just the exposed/coverage area? I need to order a piece to replace some rotted wood where the width is 90mm end to end including the tongue and thickness is 9mm. Are the online t&g widths measured...
  9. P

    T&G Chipboard Flooring - Do end joints need to be staggered?

    Hi All, I am currently re-boarding my loft after lifting old chipboard to put down insulation. I am using 22mm P5 T&G Caberfloor boards. 2400mm x 600mm. The floor was previously strengthened and levelled by running 3x2 joists at right angles across the top of the existing 4x2 joists. The...
  10. D

    Ethanol based Liberon dye

    On a new pine t& g floor, before varnishing - I was going to use the light oak to counteract the orange effect that sometimes manifests on varnished pine. How quickly will the dye dry? Presumably I'll have to get it down very quickly to avoid bolder patches of dye produced by letting an edge...
Back
Top