toilet fitting

  1. JimmyJohnJoJr

    Adding a toilet downstream of another

    Hello, I'm reworking our ensuite which is next door to the main bathroom. I want to connect the new toilet into the existing soil pipe which runs directly under it. See the picture below for the layout. Can I simply put a strap boss on to the existing soil pipe or is there anything I should...
  2. S

    Multiple Toilet Outlets

    Hi all, Hoping for some advice. I'm a self builder and I am about to put in the plumbing for 2 ensuites and a main bathroom. Each has a toilet and it's the waste pipe to soil pipe plumbing that I need a little help with. 1 toilet will go up against an outside wall so I'm OK with that one as I...
  3. H

    Wall hung toilet - no room for cistern

    I am looking at installing a wall hung toilet. There is an 80mm void between the tiles and the brick wall behind. Tiles are on a plywood partition. The bricks are suitable for anchoring the steel frame, there is enough room for the soil pipe, however the 80mm void is not enough space for the...
  4. D

    Replace soil pipe

    Hi there, I'm installing a new toilet in upstairs bathroom, trying to connect the pan to the soil pipe and it looks like the soil pipe is cracking (it's probably 30+ years old at least). It's solvent welded in place, how best can I remove and replace? Thanks
  5. A

    Toilet pan connector

    I need to replace a toilet due to a cracked cistern. I notice the pan connector appears to be what looks like solvent weld type, correct me if I'm wrong. Can the same connector be used on the new toilet or is it best to replace the pan connector as I'm not sure I can find another toilet where...
  6. R

    Toilet Waste Connection into Concrete Floor

    I am replacing a traditional toilet with a Grohe frame and I need to replace the existing waste connection (see pic below) with the one that comes with the Grohe frame. The connector goes down into the concrete floor and I have no visibility of where it goes/ how it connects. If I just yank it...
  7. bettz1

    Removing an olive from rubber pipe

    Hi what would be the best way to remove an olive from an old isolation valve which is stuck on our toilet water pipe? Was tempted to carefully use a junior hacksaw Also once off I bought a Lever isolation valve as it was a nightmare trying to turn the old one off once it started dripping with...
  8. O

    Fitting toilet to floor

    Hello - bit stumped with something. Got a new place last week and had the vinyl in the bathroom replaced yesterday. Found out this morning (the hard way) that the toilet has not been screwed to the floor. Carpenter came back to look and said they definitely unscrew anything and that it looked...
Back
Top