wago

  1. M

    Remove socket without blanking plate

    I have 3 sockets in a line in my room and would like to remove the middle one. Is it acceptable to connect its wires with wagos, put these in a wagobox, and use expanding foam to fill the cavity and polyfill over?
  2. L

    Can I connect 2 Wago connectors to make a 10 way connector?

    (Have searched but didn't find anything but would guess this has been asked before). I need to bring 6 earth conductors together on a lighting circuit into a Wago connector. 3 x for the light fittings. 2 x for the lighting radial circuit 1 x for the switch Wago don't make a 6 way connector...
  3. D

    Electric heated tower rad, fused spur outside zone 2 etc

    Bathroom being replaced/rearranged. Washing machine going in bathroom corner via new spur in hall, with upward sloping hole up to new spur backbox. Is it ok to Wago a junction in a 16mm blanked off galvanised backbox, to run a switched fused suppy for the towel rad off to the left (1000 height...
  4. A

    Wago connector size.

    Hi all, I have 6mm T&E cable going to 6mm SWA. I was going to connect them with Wago connectors. One site (TLC Direct) says Wago 773-173 Push Wire Connector 2.5mm - 6.0mm which makes sense but another site (Toolstation) says I can use Wago 221 Compact Lever Connectors 0.5 to 6mm² but on TLC...
  5. M

    Wiring a new hob: can I use Wago connectors?

    I’m in the middle of replacing a cracked electric hob with an induction hob. I’ve removed the old hob- it appears to have the twin and earth supply cable hard wired into the hob. There is no junction box visible. The replacement hob comes with an attached cable. On removing the covering plate...
Back
Top