- Joined
- 1 May 2019
- Messages
- 5
- Reaction score
- 0
- Country
Hey guys
My alarm refuses to set. I had my house redecorated last year and they installed new PIR's as the old ones were in bad condition.
Now when I go to set the alarm, it starts beeping as it would, then zone 1 LED flashes up and it makes a slower beep, then goes back to the normal beeping and zone 1 LED goes out and it does this a few times until eventually the beeping gets faster until the alarm goes off.
It's like it's detecting something in zone 1 straight away.
Any ideas?
Thanks in advance.
My alarm refuses to set. I had my house redecorated last year and they installed new PIR's as the old ones were in bad condition.
Now when I go to set the alarm, it starts beeping as it would, then zone 1 LED flashes up and it makes a slower beep, then goes back to the normal beeping and zone 1 LED goes out and it does this a few times until eventually the beeping gets faster until the alarm goes off.
It's like it's detecting something in zone 1 straight away.
Any ideas?
Thanks in advance.
