AEG 16800 washing m/c
- Thread starter wrighty01
- Start date
Sponsored Links
Did you manage to get your E10 fault resolved? I'm getting Fault E20 on the drying cycle - and it doesn't dry. Washers fine though ....would appreciate any news. Thanks sarah
Hi Sarah,
I resolved the fault by installing a new 3 way water solenoid valve in the machine sited on the top left handside of the m/c.It cost around £20 and is very easy to change if you have the right tools,i.e screwdriver and pliers.
The fault was basically one of the solenoids not opening up on the drying cycle,which allows a small amount of water into the m/c to assisit with the drying cycle.
An E20 code is also a couple of other points,
The drain hose is squashed or kinked,
The drain filter or the drain hose are clogged,
Hope this helps you out ,
Good luck Mark
I resolved the fault by installing a new 3 way water solenoid valve in the machine sited on the top left handside of the m/c.It cost around £20 and is very easy to change if you have the right tools,i.e screwdriver and pliers.
The fault was basically one of the solenoids not opening up on the drying cycle,which allows a small amount of water into the m/c to assisit with the drying cycle.
An E20 code is also a couple of other points,
The drain hose is squashed or kinked,
The drain filter or the drain hose are clogged,
Hope this helps you out ,
Good luck Mark
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
