Anyone know how to wire up all these?

[davss]

Hi All,

I have a 37CDi model, Danfoss TP5000SI-RF + RX1 thermostat, Grundfos pump (230V), 4-wire actuator (230V) and Electronic Underfloor Heating Water Temperature Stat (230V) attached to manifold. Anyone know how to wire up all these?

The system is described:
I got the 40m2 single zone pack from
http://www.ukunderfloorheating.co.uk/heating_packs_and_prices/single_zone_packs_20sqm_to_60sqm/
http://www.ukunderfloorheating.co.u...nd-additions/ufh-connected-to-a-combi-boiler/

Boiler manual:
http://bit.ly/o5qleb

RX1 wiring:
http://www.uk-plumbing.com/brochure/danfoss/RX1RX2wiring.pdf
http://www.uk-plumbing.com/brochure/danfoss/RXuser.pdf

Many thanks in advance, David

 

[davss]

It's described on another forum so I don't have to update all sites.

http://www.screwfix.com/community/message/1187311#1187311

 

[doitall]

No-0ne in their right mind goes on screwflux anymore.

 

[jarvis2]

No-0ne in their right mind goes on screwflux anymore.

Unfortunately, some of them ended up on here for a while...