Aqualisa digital shower temperature control - Pumped Twin button (LED red) part no. 223101
I think my control assembly is faulty – see below.
Can anyone advise me if the fitting of the above presents any problems. I would welcome instructions on how to open / remove and then replace the control.
My shower is 9 years old and had the processor replaced by Aqualisa engineer at my cost in February 2010. It now runs hot and cold – plenty of hot water available heated by immersion heater in an indirect cylinder. Doesn’t always flash when water temperature changes.
I have turned the mains supply off and later on to get it to reboot.
I think my control assembly is faulty – see below.
Can anyone advise me if the fitting of the above presents any problems. I would welcome instructions on how to open / remove and then replace the control.
My shower is 9 years old and had the processor replaced by Aqualisa engineer at my cost in February 2010. It now runs hot and cold – plenty of hot water available heated by immersion heater in an indirect cylinder. Doesn’t always flash when water temperature changes.
I have turned the mains supply off and later on to get it to reboot.
