Average floor tile thickness

[djc1960]

I'm about to have kitchen and utility floors screeded but have not yet decided on exact ceramic tile but I need to set the height of the screed.
Is there an average fitted thickness for ceramic floor tiles.
Ones I've fitted in the past were I think about 8mm....with about 3mm of adhesive final thickness was about the same as carpet therfore if I set the screed height to the same as adjacent carpeted floor it should be OK
Will I be able to find a good selection of tiles this thickness....most web sites don't specify the thickness of their tiles.

Thanks

 

[tictic]

what thickness is ur screed going to be!! ___mm.... 75mm i hope?
as for thickness of tiles they can vary.
have u seen tiles u like?

 

[tictic]

or have i miss read "screed"... are u using a latex compound?

 

[tictic]

sorry computer fecked ere mate..
the "screed " is it gypsum (anhydrite) 40mm

could u tell more regarding the screed

 

[djc1960]

Screed is 75/80mm sand and cement with wet UFH tied to steel mat over Celotex.
I just want to know whether the set the screed level a little lower than adjacent carpeted floor to allow for tile and adhesive

 

[tictic]

screed min 75mm
ufh should be commisioned before any tiling.
prime screed before tiling..bal sbr
powdered addy.
as for keeping level could be hit an miss
best of