B&D KW800E Router - guide bush size - advice please

Joined
28 Oct 2009
Messages
156
Reaction score
8
Location
Aberdeen
Country
United Kingdom
Hi Folks,

does anyone know the size of the guide bush supplied with a Black & Decker KW800E router. My router is at a mates house and I can't find the manual (managed to download one from B&D but it's in SLOVENČINA) :eek:

Thanks.

F
 
Sponsored Links
Big-all THANKS,

you're right unfortunately the handbook doesn't state the size of the guide. Does anyone know if they are a standard size or is that too much to hope for?

Thanks
 
Big-all THANKS,

you're right unfortunately the handbook doesn't state the size of the guide. Does anyone know if they are a standard size or is that too much to hope for?

Thanks
if you have another router the guide may fit
what are you using it for!!
 
Sponsored Links
Going to be fitting a kitchen worktop, got the router and all the bits (but not here) need to get a jig tomorrow & just wanted to check that the guide would fit the jig.

Cheers

F
 
well thats why i asked :cry:
you need a 1/2" router idealy 1600w plus
 
Thought I'd manage it in 2 passes... (3 if you count the jigsaw..)

make one (shallow) pass with the router then trim the excess worktop off with a jigsaw by sawing midway along the (routed) cut line and then just route off the excess part of the cut line??

F
 
its a 1/4" router you cant [easily]get worktop cutters for a 1/4 router
you need cutters with 50mm cutting edge what cutters have you got!!

even with an accurate jigsaw 5mm from the cut line is taking a risk
with a 800w router you are still talking 5 or 6 passes [maximum half shaft 4mm] but only 5mm so 8mm deep
 
eehhhhhh

don't know what cutter's I've got cos all the kit's at my mates house (think I've got a cutter that's got a cutting edge about 30mm long (not long enough - w/top is 38mm)).

Also pretty sure that there was a second (larger) collet (?) in the kit when I got it - need to check up on what I've got before going any further methinks.

If I can get a cutter what did you think about my 2 pass thoery - would my puny 800w router be up to the job?

Thanks again for all your help.

F
 
you dont have the correct cutters you need worktop cutters :cry:
your second collet will be 8mm :cry:

you need a minimum off the worktop depth to do a final pass
a specific worktop cutter will manage 1.5 to 2.5 joins
using a 1/4" worktop cutter [if you can find one ] will wear out 2xfaster due to 2xthe cuts over a 1/2 the cutter shank
 
Hi,

to anyone else reading this post THANKS Big-all.

After taking on-board your advice I hired a router & jig - I think I can safely say with hindsight it was well worth hiring - there's no way my puny 800W B&D would have coped.

Thanks again for your help.
 
you would have got the same advice from any one off the several dozen chippies fitters or builders on this forum :D :D lol

thanks for the feedback we all appreciate it ;)
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top