Bathroom Taps

[CADMan1]

Need help with bathroom taps.

The water from the hot tap in the bath is really running slowly. when i turn it on it runs slow but when i open it fully the water stops running.THe cold one works fine.

Then theres the bathroom sink cold tap turn it on and again it runs slowly but when you open it up full it shoots out everywhere there is no in between, and when you turn it off there is a loud bang in pipes.

Can anyone give me a tip on how to solve these issues

Thanks

 

[Softus]

The water from the hot tap in the bath is really running slowly. when i turn it on it runs slow but when i open it fully the water stops running.THe cold one works fine.

Sounds like the jumper, or the washer, has come adrift.

Do you know how to shut off the supply to it? If so, do that, then remove the handle, then unscrew the valve body and inspect it.

Then theres the bathroom sink cold tap turn it on and again it runs slowly but when you open it up full it shoots out everywhere there is no in between, and when you turn it off there is a loud bang in pipes.

Same comments as above.

 

[CADMan1]

ok cheers will give it a try. even though dont know what im looking for.

 

[Softus]

They're not very complicated things, but if you can't work it out then just post a picture here and you'll get advice.