I have to cut a square hole (approx 20cms) in the side of a kitchen base unit carcass to allow access to a stop cock. I want to get a clean hole with minimal chipping of the laminate. What would be the best way to do this, jigsaw, router or handsaw? I can remove the side panel to cut it
cutting hole
- Thread starter davecooper
- Start date
Sponsored Links
I'm assuming you only need the inside face to have a good finish Dave - I'm guessing that you won't be able to see the outside face? In this case a jigsaw would be fine but cut from the side that you won't see then any splintering would be restricted to that side only. Or cut from the good side with a downcut blade.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
