fascias and dry verge tilese

[jt81]

Hi, I was wondering if you could help me. I have recently just had a builder do the fascia’s, soffits and gutters of my house.

1. The dry verge tile at the eaves – should this be fully fitted at top and bottom, with no gap showing?
2. The ridges end cap looks slightly angled rather than straight/flush

Should this be the case?

 

[simonjay]

Hi, I was wondering if you could help me. I have recently just had a builder do the fascia’s, soffits and gutters of my house.

1. The dry verge tile at the eaves – should this be fully fitted at top and bottom, with no gap showing?
2. The ridges end cap looks slightly angled rather than straight/flush

Should this be the case?

I think you would need to post a few photos.

 

[jt81]

Hi, Its not really that clear especially the ridge top

 

[noseall]

Hi, Its not really that clear especially the ridge top

It must be to you or else why would you complain. Do you need binoculars to see it?

 

[jt81]

Well its high up so it is going to be really obvious unless you properly look but that's not to say its not right.
There is a gap where it should be sealed and the ridge plate doesnt look flush or in line with the tiles

 

[jt81]

Can you see the photos? I've added them as a album bit not clear there on this thread

 

[noseall]

Have these dry verge caps been retrospectively fitted?

If so, how many tiles did the fitter remove?

 

[jt81]

No he did the full job - fascias, soffits and dry verge tiles. He will be coming round at some stage though hes taking his time so I will be querying it anyway.

 

[noseall]

No he did the full job - fascias, soffits and dry verge tiles.

Yes, but did he do a proper job or did he just fix the dry verge caps into the verge mortar?

 

[jt81]

A paid for a proper job