fitting bath to walls that are no square

[b21playa]

Had walls skimmed not long ago and put bath against wall today to notice that there is a 1/2" gap on the short side at the head end outer corner.

To overcome this and to get a tight seal, should i chip the plaster and set the bath into the plaster to the edge is flush with the wall?

I know it means there wont be a uniform edge going around but better then it leaking

Thanks

 

[seco services]

as you say just take the corner in slightly that will level other corner better. then you still have tiles to go on so you loose the 1/2"
mark the corner edge with a pencil etc, then the bath will be better surported on that corner when resting in the channel

 

[b21playa]

as you say just take the corner in slightly that will level other corner better. then you still have tiles to go on so you loose the 1/2"
mark the corner edge with a pencil etc, then the bath will be better surported on that corner when resting in the channel

Perfect