I would like to fit a mixer tap to an old ceramic sink. The current taps (I'm assuming 1/2" BSP fittings) are fitted in the outer corners about 400mm apart. The only options I can think of are:
1. A dual fitting which would breach the gap. I can't find anything like this, and am pretty sure it would look clumsy anyway.
2. A monoblock in one of the tap fittings. I'm not sure the hole would be big enough - is this right? Also how to blank off the unused hole?
Can anyone advise on these options or any other way of getting a mixer tap in without replacing the sink?
1. A dual fitting which would breach the gap. I can't find anything like this, and am pretty sure it would look clumsy anyway.
2. A monoblock in one of the tap fittings. I'm not sure the hole would be big enough - is this right? Also how to blank off the unused hole?
Can anyone advise on these options or any other way of getting a mixer tap in without replacing the sink?
