- Joined
- 5 Jan 2019
- Messages
- 2
- Reaction score
- 0
- Country
Hi. I recently had a plumber come round as my combo boiler is not giving out hot water. It heats up and then goes luke warm and then cold. Radiators are fine. He charged me £220 to replace the plate to plate heat exchanger, but it didn't resolve the issue. He said it normally would have.
He advised to get a magna clean and fit it myself because the main heat exchanger was also kettling, and although he had swapped the plate to plate one which was full of crud the main one would be too expensive to do (in his word's) , and putting in a magna clean with some fernox should resolve it.
He said if it didn't work after a few months then to get a power flush. I was advised this would be the most cost effective route.
Any ideas, comments before I go and splash out on a magna clean.
Thanks.
He advised to get a magna clean and fit it myself because the main heat exchanger was also kettling, and although he had swapped the plate to plate one which was full of crud the main one would be too expensive to do (in his word's) , and putting in a magna clean with some fernox should resolve it.
He said if it didn't work after a few months then to get a power flush. I was advised this would be the most cost effective route.
Any ideas, comments before I go and splash out on a magna clean.
Thanks.