Ive got my alarm installed and powered up but I think im miss reading my engineer manual.
ive only got 1 door contact set up on connection 1 (no tamper connections yet)
when I set the alarm and close the door I get the count down tone, but as soon as the exit count has finished the entry tone starts and then the alarm sounds.
When I try to do a walk test and press 0 to go into the walk test program I get all 8 zone lights on and a constant dual beep beep tone. According to the manual this shouldn't happen. I press the tick button to reset the walk test zones and zone 1 led turns off, when i open the door it comes back on as it should.
Ive only got zone 1 set as used.
what have i done wrong?
ive only got 1 door contact set up on connection 1 (no tamper connections yet)
when I set the alarm and close the door I get the count down tone, but as soon as the exit count has finished the entry tone starts and then the alarm sounds.
When I try to do a walk test and press 0 to go into the walk test program I get all 8 zone lights on and a constant dual beep beep tone. According to the manual this shouldn't happen. I press the tick button to reset the walk test zones and zone 1 led turns off, when i open the door it comes back on as it should.
Ive only got zone 1 set as used.
what have i done wrong?
