Hi, could any of you guys tell me if this idea would be OK for the regs etc ?
At present, I have an outside tap that just supplies cold water, I would like to be able to have the facility to have hot water via this same tap occasionally so what I propose to do is run pipes from the hot and cold feeds via double-check service valves to a tee and then onto the tap.
Would this satisfy the water regs etc ? The hot water is supplied from a separate Hot Water Boiler fed from the Cold Water Main and the Cold is fed via the Main Directly.
Finally, I've been given enough plastic pipe to do the job, so can you buy push-fit double-check valves, or would I have to buy a length of copper for either side of the valves, so they can be soldered/compression fitted ?
Thankyou
At present, I have an outside tap that just supplies cold water, I would like to be able to have the facility to have hot water via this same tap occasionally so what I propose to do is run pipes from the hot and cold feeds via double-check service valves to a tee and then onto the tap.
Would this satisfy the water regs etc ? The hot water is supplied from a separate Hot Water Boiler fed from the Cold Water Main and the Cold is fed via the Main Directly.
Finally, I've been given enough plastic pipe to do the job, so can you buy push-fit double-check valves, or would I have to buy a length of copper for either side of the valves, so they can be soldered/compression fitted ?
Thankyou