This machine has been tearing holes in woollens(using hand wash cycle) and tshirt fabrics. Was seen by a mechanic and fixed!!! but now new holes appearing. Reluctant to pay for the engineer again as I\\\'m now just out of warranty. Any ideas?
Hotpoint aquarius WF 630
- Thread starter henry63
- Start date
Sponsored Links
B
breezer
it depends on the holes as to the cause (honest)
are they little round holes or not round holes but tears?
are they little round holes or not round holes but tears?
Sponsored Links
B
breezer
henry63 said:
You are not going to like this.
small round holes are caused by the items going through the holes in the drum then being "sliced" by the heater (usualy its the heater) they get through the holes because centrifugal force, forces them through the holes.
The centrifugal force is too high. i.e wrong spin speed (i said you wouldn't like it)
I once got called out for similar, i picked up the garment in question, looked at the wash care label, gave it to mr customer said goodbye, and as i left said "read the label mate" as i shut the door Mr customer was shouting at mrs customer (thats why i left)
and the label said.........................................
hand wash only
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
