Hotpoint WF560 not completing the wash cycle

[Mazzi]

Hi, I have found this forum very helpful and seen lot of good advices and fixes. I have a problem with my Hotpoint washing Machine WF 560. It is stuck with only a wash cycle and not doing anyother cycle. I have seen the LED error 2,3 and 4. I don't know what does it mean.

Also when I have switched the machine OFF and ON after that I was just filling the water contineously with no drum movement. I have to swith OFF the WM before the water lavel reached upto the half of the door.

Could someone please advice. I am just simply not sure what's going on with it.

Regards,

 

[rocks1]

That error is f07 heater or heater relay on pcb. Have u put it on spin and see if the water drains check the presure pipe is connected. Then the filter.

 

[Mazzi]

Many Thanks for your response. I have taken the heater element out and checked the Resistance on both terminals through multimeter and it's 0.
So It's mean it heater element?

 

[Mazzi]

Machine does drain. But On this WF560 model there is no filter. There is noting under the buttom front panel.

 

[rocks1]

Yep heater is shot, the filter is at the back.

 

[Mazzi]

Hi I have replaced the heater today and after wash cycle WM started the water Drain and stuck on it. There was a pump sound for long time and after that flashing 2 and 4 LED. What it could be this time?

There is filter at the back of the machine does any have any instructions how to clean that filter.