When I was replacing the bearings on my Hotpoint WM63P machine I removed the front panel and turned it to one side then I removed the drum clips and then withdrew the drum plate together with the heater and turned this to one side also.At this point I noticed a strip of black 'L' shaped plastic about 4 to 5 inches long on the floor and no idea where it came from.I replaced the bearings and rebuilt the machine and all works well but does anybody know where the black plastic strip should go.
Hotpoint WM63P 'L' shape plastic strip.
- Thread starter moclam
- Start date
Sponsored Links
B
breezer
picture ?
picture info is in forum information
picture info is in forum information
Agree with the above black trim normally two of these to protect the interlock cables ect rubbing on the case can normally be put back by removing door seal from front panel and reaching through.
disconnect the electric supply of course befor attempting!!
disconnect the electric supply of course befor attempting!!
Sponsored Links
B
breezer
I wonderred that, but he said L sahpe that nit of plastic is more a U shape (well they used to be, didnt they?)
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local