Am currently having a lock issues with an Indesit machine (iwde 126).
Couple of months ago, It burnt out the cables at the rear of the lock and the lock mechanism had broken plastic in parts so was replaced and wires striped back and good connections made.
Yesterday the cables burnt again and though this time the lock was ok, so stripped back cables and reconnected.
Now for some reason the lock section works fine but any washing program the machine just fills up once and then unloads water constantly, but all the drying programs all seem to work fine?
I am thinking the lock issue damaged the pcb, or damaged a sensor, or both?
Any ideas where to start, and has any one got schematics for the board at least that way I can try and check input/outputs. Have electrical and electronic training so can go in deep with this
Couple of months ago, It burnt out the cables at the rear of the lock and the lock mechanism had broken plastic in parts so was replaced and wires striped back and good connections made.
Yesterday the cables burnt again and though this time the lock was ok, so stripped back cables and reconnected.
Now for some reason the lock section works fine but any washing program the machine just fills up once and then unloads water constantly, but all the drying programs all seem to work fine?
I am thinking the lock issue damaged the pcb, or damaged a sensor, or both?
Any ideas where to start, and has any one got schematics for the board at least that way I can try and check input/outputs. Have electrical and electronic training so can go in deep with this
