Indesit W123 Help Needed

[mono]

I have just acquired one of these machines,but i dont have a manual for it, is this machine a cold fill? Only i have plumbed it in and done a load of washing but when the washing comes out the machine the clothes are cold, so i dont know whether the heater is working or not.
Any help would be apprecited.
Thanks

 

[kevplumb]

but i dont have a manuel for it

wasn't he a waiter in faulty towers

 

[Softus]

I have just acquired one of these machines,but i dont have a manual for it, is this machine a cold fill?

If it has only one inlet then it's a cold fill, but even a machine that takes in hot has a heater, so you must have heater fault.

Having said that, most machines won't complete the cycle if the water doesn't reach the preprogrammed temperature.

 

[mono]

Its doing the full cycle, but the machine an the glass door aren't even slightly warm, so could it be the heater?

 

[Softus]

I'm no expert, but it sounds more like a programmer fault. I think you need a specialist.

Or you could try this site: http://www.ukwhitegoods.co.uk

 

[Sleepyhead]

Most likely theres no fault. If the heater doesn't heat the water it won't go through the cycle.
The clothes are cold when you take them out because it rinses 3 times with cold water.

 

[Softus]

The clothes are cold when you take them out because it rinses 3 times with cold water.

A very good point.

mono - are the clothes actually being cleaned, or remaining grubby?