Is PVA glue toxic? (we have damp and mould)

[Deansplit]

I have an ongoing problem with the inside of a set of drawers and the base of a cot (both MDF) attracting mold - the house we are in is a temp measure while we get our renovated and is damp! I have cleaned off the carpet of mold spores found on the MDF and wondered if sealing with PVA would prevent any further mold developing on it, but my wife is concerned that anything used in a cot is critical that it's not toxic as this is one of the reasons they say causes cot death.

Also, why does MDF attract mold so easily, does it hold a lot of moisture?

Thanks for any help

 

[big-all]

you do better to cure the damp problem that should be your main concern

you need ventilation to remove the damp

if you dry washing on the radiators thats a no no
look here for suggestions
//www.diynot.com/wiki/building:condensation_in_houses

 

[r896neo]

children especially babies have a very significantly increased risk of respiritory problems due to exposure to black mould caused by condensation. If it is that bad i would definately consider moving the cot to a better ventilated room.

I don't mean to panic you, of course these studies are based on a more medium to long-term situation but it is definately bad news for little ones even for a short period.

 

[foxhole]

Mold will grow on just about any surface, as mentioned your concern should be to remove damp air by ventilating the room to avoid mold growth.

 

[JohnD]

yep... if you have mould, start with ventilation.

you don't drape wet washing about the house, do you? it is the worst cause of condensation in houses.

more on //www.diynot.com/wiki/building:condensation_in_houses

a hard floor (e.g. vinyl or laminate) is easier to keep clean in a baby's room, and will not harbour dust or spores