JCBd-pr12f router

[G1zm0]

Hi guys. Got this routerJCBd-pr12f and it only came with a 6 collet ( it was from ebay)
So need a half inch collet for this device, any one know whats suitable and where to get it .
Also need instructions for this device as it comes with few bits and dont know what they are.

Using it for kitchen jig

 

[G1zm0]

Anyone

 

[big-all]

do you mean 6 cutters ??
6 collets are a lot
is it a 12mm router or a half inch router??
if its 12mm you may not be able to get a 12.7mm/1/2" collet

 

[G1zm0]

Its just the sleeve to hokd the 1/2 bit

 

[big-all]

it will be a collet rather than a sleeve
not being pedantic you understand as hitachi use sleeves to reduce from 12-8mm or 6.35mm
try some where like solent tool spares they are pretty good for generic/re-badged or imports spares