Link-and-Light-Ultraslim-16W-Triphosphor-Strip-Light

[highlandlass]

Hi Does anyone know how to change the bulb in a Link-and-Light-Ultraslim-16W-Triphosphor-Strip-Light

 

[PrenticeBoyofDerry]

Try pushing one end in and this should allow the opposite end to exit the terminal, then you should be able to bring it free.

 

[Taylortwocities]

A link to the product would help.

Or try turning the tube 90°

Or ask on the electrical section of your local B&Q. They know everything there!

 

[highlandlass]

http://www.diy.com/nav/rooms/kitche...-T4-Cabinet-Light-20W-11597593?skuId=12108299

Have tried always to remove but unsuccesful

 

[PrenticeBoyofDerry]

They should just clip in, is there any spring in the ends if push them outwards?

 

[highlandlass]

No the ends are fixed. Taking dog to vets on Monday so will take it to B&Q

 

[PrenticeBoyofDerry]

Can you upload a few pictures of the unit, from underneath, side and end.

 

[flameport]

Plastic transparent cover unclips / pulls off.
Rotate tube to remove.

 

[highlandlass]

http://media.diynot.com/103000_102311_72045_33008084_thumb.jpg//mediahttp://media.diynot.com/103000_102311_72046_60628829_thumb.jpg.diynot.com/103000//media.diynot.com/103000_102311_72047_46076800_thumb.jpg_102311_72044_93135217_thumb.jpg

 

[PrenticeBoyofDerry]

Looks like a quarter turn and slide out!

 

[333rocky333]

Untitled

• highlandlass
• 18 Jan 2014
• 1

As above
twist the lamp till you see pin alighned with slot then pull both ends sguarely up and out of slot.they can be tight
To refit lamp slot in and twist 90 degrees
It is best to isolate power when changing these lamps as you can blow the electronic control gear