Looking for a specific nut. Do they make it?

[Mikendo]

Simple...
Hex nut. With high torque holes in side - not for turning, but more for holding while turning the bolt.

Imagine the bolt is in a small place where only a metal rod can hold the nut so it doesn't spin while turning bolt.



I see high torque circle thumb nuts, but I want a hex.

Is there a name for this?
If not can I get this fabricated? Where (usa only)

Thanksssss!!

 

[Burnerman]

Why not saw a slot across the hex, then run the bolt through a few times to clean up the thread.....you can then use a screwdriver to lock the hex enough to allow you to tighten up.
John

 

[ntb]

A Castle Nut might work.

 

[Dave54]

Or drill a hole (or several) in a standard nut? You don't say what it's for, or how big the nut is, but the usual solution to this is either a captive nut of some sort, or a tapped (threaded) hole if the material is thick enough. Not really much help if that's what you're stuck with though.