A friend of mine wants to move his CH pump (i don't know why) and i was wondering if this is a relatively straightforward job that he could do himself?. I assume he would need to drain down his ch circuit to below level of pump, undo the nuts, remove pump, alter pipework and remount the pump. Does this sound correct to you knowledgable ppl ?
Moving a CH Pump.
- Thread starter dreamer66
- Start date
Sponsored Links
sounds all ok but move to where ?
Why does he want to move it? I suspect it's on a gravity system behind a back boiler?. The pump needs to be 150mm or as close as possible and after to the open vent & cold feed configuration. This will limit sludge/pumping over/ noise problems/pump failure etc in the future.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links