Having looked through the forum, I was wandering if anyone could give me some advice on connecting a new toilet into a new waste pipe.
I was hoping to be able to attached a drawing on here, but I will try and post it into my albums on my settings and also add a new post.
I will be fitting 2 new toilets back to back on the other side of a dividing wall. The pan connector will be a FloPlast 90 deg connector. The run off will be along the back wall internal of the attic running along the lower part of the roof trusses out through the gable end of the wall and then down to the sewer. I will be fitting only one of these toilets (the right hand one initially) and the left hand one next year. Also there will be a sink next to each toilet so I need to get rid of that waste too. What will be my best options for connecting the right hand toilet into that wast pipe, and the left hand toilet later, also to connect the basin waste for bother. Very kind regards.
I was hoping to be able to attached a drawing on here, but I will try and post it into my albums on my settings and also add a new post.
I will be fitting 2 new toilets back to back on the other side of a dividing wall. The pan connector will be a FloPlast 90 deg connector. The run off will be along the back wall internal of the attic running along the lower part of the roof trusses out through the gable end of the wall and then down to the sewer. I will be fitting only one of these toilets (the right hand one initially) and the left hand one next year. Also there will be a sink next to each toilet so I need to get rid of that waste too. What will be my best options for connecting the right hand toilet into that wast pipe, and the left hand toilet later, also to connect the basin waste for bother. Very kind regards.
