Hi All,
I'm hoping that I'm being stupid . . .
I have a Fireside 50 back boiler. I have been in this property 2 months without any issues. This boiler runs the central heating. Hot water is via an emersion heater.
I had a new (gas) cooker fitted 2 days ago. During this operation the engineer turned off the main gas stop cock before turning it on again. Following this I tried to light the boiler (for the first time, the previous owners had left it lit). I can see a spark when I press the ignition but no pilot flame lights. There are no room thermostats in the house, the water system is full, the pump feels as though it is working and I have tried various combinations of timer switch settings. I've adjusted the output to its lowest setting (N) (and also tried to light it at it's highest setting 7 - a long shot I know). Still no luck.
Any ideas greatly appreciated.
I'm hoping that I'm being stupid . . .
I have a Fireside 50 back boiler. I have been in this property 2 months without any issues. This boiler runs the central heating. Hot water is via an emersion heater.
I had a new (gas) cooker fitted 2 days ago. During this operation the engineer turned off the main gas stop cock before turning it on again. Following this I tried to light the boiler (for the first time, the previous owners had left it lit). I can see a spark when I press the ignition but no pilot flame lights. There are no room thermostats in the house, the water system is full, the pump feels as though it is working and I have tried various combinations of timer switch settings. I've adjusted the output to its lowest setting (N) (and also tried to light it at it's highest setting 7 - a long shot I know). Still no luck.
Any ideas greatly appreciated.