Prima Dishwasher LPR 600

[dacowey]

Please can anyone help me out? As soon as the dishwasher is turned on, the drain pump runs for approx 30 secs, then cuts out. Then it sounds like the cycle begins, apart from there doesn't seem to be any water going in. Then after approx 5 mins the fault tone sounds and the light flashes in a sequence, 4 times each sequence. I've had 2 people out to look at it, but they aren't able to fix it, saying that there is something wrong with the program. Any help would be most greatly appreciated as I don't fancy washing the xmas dishes by hand. Cheers
____________________
moderator

please note forum rules 5, your post has been edited

 

[tiredengineer]

This one is a Whirlpool machine. 4 flashes is a draining fault.
Check that everything is clean and free from blockage, especially the drain hose where it connects to the spigot under the sink (unless it's into a stand pipe).
There's a pressure switch in the sump of the machine, these can get clogged up and will cause various errors to be shown.
Finally, it could be a problem with the control module.


Unplug your appliance before working on it