I am currently having to top up the Water Pressure on my Vokera boiler daily:
I have the Hot Water Thermostat set to 9 (max) and the Heating Thermostat set to 2 / 3.
In the morning the pressure tends to have dropped to 0 - if I put it up to 1.5 (the top of normal recommended) when out of timed heating periods then it is ok for a while.
If the Heating thermostat is set higher than 3, the pressure jumps to to almost 3bar (shut off level) once the timed heating kicks in. Keeping it at 2/3 leaves it at an above normal reading of 2 Bar. Once the timed heating period is finished it drops steadily to 0 again.
If the heating is higher than 2 / 3 then the shower tends to go cold frequently, with bursts of intense heat.
Is there anything I can do? Or is it just gubbed and needing an expert.
Please note: I have bled the radiators and checked the joints of the above floor pipework and found no leaks. I do not have access to beneath the floor to check there tho...
Any help much appreciated!
I have the Hot Water Thermostat set to 9 (max) and the Heating Thermostat set to 2 / 3.
In the morning the pressure tends to have dropped to 0 - if I put it up to 1.5 (the top of normal recommended) when out of timed heating periods then it is ok for a while.
If the Heating thermostat is set higher than 3, the pressure jumps to to almost 3bar (shut off level) once the timed heating kicks in. Keeping it at 2/3 leaves it at an above normal reading of 2 Bar. Once the timed heating period is finished it drops steadily to 0 again.
If the heating is higher than 2 / 3 then the shower tends to go cold frequently, with bursts of intense heat.
Is there anything I can do? Or is it just gubbed and needing an expert.
Please note: I have bled the radiators and checked the joints of the above floor pipework and found no leaks. I do not have access to beneath the floor to check there tho...
Any help much appreciated!