I have a statsman flowsure + oil combi boiler, the temp is hitting 90 and the pressure at about 3 bar or more. is this right? it seems a bit high to me. also it drips quite a lot out of the vent in the wall. the thermostat on the boiler is turned right down. we haven't got the heating on any more and its still spanking oil. any suggestions to what it could be?
problem with flowsure +
- Thread starter vr6dub
- Start date
Sponsored Links
W
wilhelm
exp vessel forked
ev underpressurised
control stat forked
blocked ev hose
pump forked,
Take yer pick.
ev underpressurised
control stat forked
blocked ev hose
pump forked,
Take yer pick.
nice. i feel a new boiler might be needed 
Why a new boiler?
You say its 3bar and dripping are you repressurising ?
could the filling loop be open?
but it sounds like a pressure vessel problem.
Not a new boiler.
drain some water out so it reads 1bar
disconnect the filling loop
see what happens and reply here
You say its 3bar and dripping are you repressurising ?
could the filling loop be open?
but it sounds like a pressure vessel problem.
Not a new boiler.
drain some water out so it reads 1bar
disconnect the filling loop
see what happens and reply here
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
