i have a pvc door and when it was installed a few months ago the door bell was fitted on with a sealant that was used to seal around the door and windows and now it has come loose from the door ,is there special screws that i can put it back on with or what do i do as it is just hanging there now cheers
pvc door
- Thread starter hawthorns
- Start date
Sponsored Links
assuming its a plastic bell push
i would give it another go thoroughly clean the frame and bell push then a couple of small blobs of silicone then when set a bead round the edge
failing that you can use any normal wood screw into plastic or ally with a sutable pilot hole drilled if your using brass screws use a steel screw to form thread in ally first
i would give it another go thoroughly clean the frame and bell push then a couple of small blobs of silicone then when set a bead round the edge
failing that you can use any normal wood screw into plastic or ally with a sutable pilot hole drilled if your using brass screws use a steel screw to form thread in ally first
be careful - it may well be that if you drill holes in the door you will invalidate the warrentry
best thing - skip it and fit a proper wooden door
best thing - skip it and fit a proper wooden door
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local