Pyronix Deltabell Plus Help

[kajo]

Hi Guys,

Just bought a new pyronix delta bell plus to replace my old bell box with sab.
My panel is the old Horizon alarm panel I think there is only 4 or 6 wires coming from the panel to the old alarm bell box.
I see a few jumpers in the pyronix not sure if I have to move them or not and it also came with a resistor again not sure if I need to use that.
Looking at the connections in the pyronix has me a little lost so any advice would be great.

pyronix delta bel
https://s18.postimg.cc/xxren06dl/20180430_150315.jpg

Panel Wires
https://s18.postimg.cc/fgomwb7o9/pic1.jpg

https://s18.postimg.cc/j0akm72p5/pic2.jpg

Found this in the paper work I think this is the exact way it was wired.
https://s18.postimg.cc/u5chl25zd/20180430_154817.jpg

 

[sparkymarka]

Wire as diagram ( 4 wires ) ...blue is 0v and you have to link it to the other tamper terminal in the deltabell and the yellow goes in the other , the only link you need to set is the battery link to internal ...
Black in the bell
Red in the +
If you have 2 spare ( green and white ) use for strobe in the bellbox , if not link strobe to bell in the bellbox

 

[kajo]

Great thank you not sure yet how it looks in the old bell box but the green and white are connected into the internal sounder located in the panel.
I take it the green and white are going to the strobe in the old bell box builders just pulled it off the wall and left it hanging and the screw is messed up.
If all goes well I will post here and let you know thanks again.

They left the box in a bit of a mess

https://s18.postimg.cc/tu8tdmwah/20180430_192922.jpg

https://s18.postimg.cc/7ib0k9cm1/20180430_192819.jpg