Pyronix Euro 46 V10 Input types

[kazgaz]

Hi everyone

Just temporarily setup my new above alarm panel on the bench with bell box, internal sounder, battery, keypad & one Pyronix PIR connected. Reason for this is to get my head around the programming before I install it for real. (It's replacing an Accenta G4)

My exit point in the house has a PIR in the hall, no door contact. I set Input 1 type for "final exit" but when I set it to Area A the alarm started the exit timer but it carries on indefinitely, it does not set. I know it probably something simple but a little advice would be appreciated.

Cheers guys.

 

[sparkymarka]

Check setting options

 

[kazgaz]

Hi sparkymarka

Do you mean check the input type? I'm thinking it should have been set to No 10 FX (Area ER) not No 7 Final Exit?

Cheers for the response.

 

[sparkymarka]

No setting option , could be timed , final exit , exit terminate

 

[kazgaz]

Ok, no problem. I'll have another bash at it as I've disconnected everything. The missus was complaining about the exit tone!

I'll follow up on here once I hopefully get it sorted!

Thanks again.

 

[Alarm Engineer]

System options > exit modes > A Timed Exit.

System timers > A Exit > Select desired time.

Volume control > A Exit 2 > B Exit 1 > A Entry 2 > B Entry 2.

A final exit door Contact is Recommended

 

[kazgaz]

Thanks Alarm Engineer

Gonna take these great suggestions when I install it for real. Can't wait to replace my Accenta. The difference in build quality alone is streets ahead!

Thanks again.