- Joined
- 2 Jul 2010
- Messages
- 237
- Reaction score
- 4
- Country
Hi,
Can anyone please advise me the best method to repair an external wood window frame stanchion that has a splintered section missing. I looks as though a section of the frame has been pulled off at some point and then the uneven remnant just pained over.
I have attached a picture of the area requiring repair below.
The section needing repair is about 8 inches long and the window to the right of the repair opens.
My first thought was to open the window to the right and place a flat edge at 90 degrees to the front view then fill the section with Toupret Murex. Then, try to remove the flat edge with minimal disturbance to the edge, however, I am not sure if this is the best method so any suggestions most appreciated.
Rgds
Can anyone please advise me the best method to repair an external wood window frame stanchion that has a splintered section missing. I looks as though a section of the frame has been pulled off at some point and then the uneven remnant just pained over.
I have attached a picture of the area requiring repair below.
The section needing repair is about 8 inches long and the window to the right of the repair opens.
My first thought was to open the window to the right and place a flat edge at 90 degrees to the front view then fill the section with Toupret Murex. Then, try to remove the flat edge with minimal disturbance to the edge, however, I am not sure if this is the best method so any suggestions most appreciated.
Rgds
