Scantronic 9600 Panic button interface

[wildeone]

I want to install a wireless trigger from my smart homesystem to trigger my Scantronic 9600 alarm system. But its not clear from the operating manual which are the panic button terminals I need to connect to.

It looks like there may be a way to connect to the remote panel I/P 0v but again its not clear, well at least to me

Any advice on this would be really appreciated thanks

 

[Europlex]

There is no dedicated PA circuit in this panel.

Pick any circuit you like, you then have to prog. it as audible or silent PA. It is just like programming any other circuit.

It is in the installation/programming manual.

 

[wildeone]

Thank you Europlex I have found the right section in the manual

Do you need to treat the PA contactor as a normal open. Closed on activation of the PA switch?

 

[Europlex]

PAs are wired CLOSED CIRCUIT, so on pushing them they go OPEN CIRCUIT.

Hope you have the Twin Button sort, less chance of activating it accidentally.