Hello there,
I recently replaced my old mechanical control for the central heating with a digital Siemens Rev100 control.
My electrician installed it but later lost the user and installation manual, and thus i am left with a unit that seem to turn on the central but cannot set it.
The control does not show any room temperature and i can also not calibrate it (in calibration mode no command can be entered on the touch screen, no temperature is showing either).
All in all I have the feeling that the sensor is not connected / operating.
Does anyone have experience with this?
a little lost, so thanks a lot for any helpful remarks!
b.
I recently replaced my old mechanical control for the central heating with a digital Siemens Rev100 control.
My electrician installed it but later lost the user and installation manual, and thus i am left with a unit that seem to turn on the central but cannot set it.
The control does not show any room temperature and i can also not calibrate it (in calibration mode no command can be entered on the touch screen, no temperature is showing either).
All in all I have the feeling that the sensor is not connected / operating.
Does anyone have experience with this?
a little lost, so thanks a lot for any helpful remarks!
b.